A semiautomatic tamp type label applicator. This tabletop unit applies labels to flat and slightly curved surfaces.
Electric motor advances labels. Motor is footswitch activated and light sensor controlled . Labels are applied by depressing the tamp applicator.
Three adjustable guides are provided for accurate positioning of articles.
Can label articles with a thickness of up to 5 3/4 inches.
Optional finger applicator pad aids in adhering labels to curved surfaces and articles with recessed surfaces such as plastic lids.
Liner paper is rewound for easy disposal
Label supply roll – max 10” diameter, 3” core ID
Label length: 3" min, 9" max
Label width: 2 1/2" min, 6" max
Die cut labels with a minimum 1/8” gap between labels
Durable steel and aluminum construction. Powder coated finish.
Electric: 120 volt AC
Approx. Weight: 59 pounds
Abilities and Limitations
Can apply square, rectangular, oval and round labels.
Contact us if your labels have unusual cutout shapes or are made from very flexible material such as plastic film (BOPP) or acetate. Labels require some stiffness to work properly in our machines.
Labels are pressed onto articles with the tamp plate however the plate does not reach the label edges. You may need to press the labels by hand (either individually or in a stack) to completely adhere the edges.